10W Path Audio

PathAudio Resistors are developed and designed for the best quality Hi-End Audio.
Their design ensures excellent transmission of the full audio bandwidth, without audible distortions, and with extremely low noise floor.
PathAudio resistors have a wide frequency response with negligibly low impedance phase shift, providing superior quality audio processing.
They have 1% tolerance, a low temperature coefficient and high heat dissipation, without the vibration effects.

The resistors are made with thick film technology.
The resistive layer is applied to the molded ceramic body.
Then it's dried with high temperature and encapsulated with silicon cement.
After applying 0.8mm tinned copper leads, the resistor is almost ready to play.
For the ultimate mechanical stability and shielding advantages, it's put into the copper tube and flooded with the best quality resin.
The use of copper tubing allows to drain interference's and this is why we used the third long lead out.
It's connected only to the casing, having no contact with the signal transmitted by the resistor.
This third lead out should be joined to the ground or "-" speaker input.

PathAudio resistors are perfect for loudspeaker cross-overs allowing the sound to be smooth and clear with superb dynamics.

Parameters:
Non magnetic
Ultra low inductance
Tolerance +/- 1%
10 Watt power rating
Maximum voltage 1500 V
Dimensions (length x diameter) 60 x 12 mm
Wire length 35 mm, diameter 0.8 mm
Ground wire length 13-15 cm